Testing alarms

Before you start testing alarms. Check that AMS has been taken in the room and that it is OK.
Check whether the alarm you are going to test is time-controlled off
Please make sure that presence marking for personnel is not activated in the room you are testing alarms.
Check that alarms are activated.
At Service recipient - Alarm settings
To activate alarms, select the ones you want and then press Update alarm . Alarms should now be activated.

Test that alarms enter Nattugla Administrator or Hepro Respons mobile

If you have present marked - make sure that this is not activated. It will turn off all alarms.
check whether the alarm you are going to test is timed off
Test one of the selected alarms you chose to activate.
Fall alarm. Stand up straight and lie down on the floor. After about 20-60 seconds, an alarm will be sent from Nattugla.
Up and out of bed. Lie down in bed and lie down for at least 30 seconds. Get up and leave the bed. Alarm is sent from Nattugla.
Leaving chair. Sit in the chair and wait at least 30 seconds. Get up and leave the chair. Alarm is sent from Nattugla.

If you don't find the answer to your question, don't worry, we are here by your side.
Hepro : + 47 400 044 43
Easymeeting : +47 400 04 887